• [单选题]某网络中,拟设计10子网,每个子网中放有14台设备,用IP地址段为199.41.10.X,请问符合此种规划的子网掩码是()
  • 正确答案 :C
  • 255.255.255.240


  • [单选题]You have a class C network, and you need to design it for 5 usable subnets with each subnet handling a minimum of 18 hosts each. Which of the following network masks should you use?
  • 正确答案 :D
  • 255.255.255.224

  • 解析:解析:Explanation:ThedefaultsubnetmaskforclassCnetworkis255.255.255.0.Ifonehastocreate5subnets,then3bitsarerequired.With3bitswecancreate8subnets.Theremaining5bitsareusedforHosts.Onecancreate30hostsusing5bitsinhostfield.Thismatcheswiththerequirement.IncorrectAnswers:A,B:ThisisanillegalsubnetmaskforaclassCnetwork,asthethirdoctetcannotbedividedwhenusingaclassCnetwork.C:ThisisthedefaultsubnetmaskforaclassCnetwork.Itprovidesforonenetwork,with254usablehostIPaddresses.E:Thissubnetmaskwillprovidefor14separatenetworkswith14hostseach.Thisdoesnotmeettherequirementofaminimumof18hosts.

  • [单选题]如果把路由器的某个端口的IP配置为:192.168.10.64,掩码配置为:255.255.255.248,则该端口()
  • 正确答案 :B
  • 会变成“administratively down”状态


  • [单选题]A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?
  • 正确答案 :A
  • All defined VLANs are allowed on the trunk by default.

  • 解析:解析:Explanation:

  • [多选题]属于私有IP段的是()
  • 正确答案 :ABD
  • 10.0.0.0-10.255.255.255

    172.16.0.0-172.31.255.255

    192.168.0.0-192.168.255.255

  • 解析:ABD

  • [单选题]为了连接“帧中继”线路,网络中的路由器需要提供的端口类型为()
  • 正确答案 :B
  • Serial


  • [单选题]网关的功能()
  • 正确答案 :B
  • 不同网段通信


  • [多选题]Which of the following steps are necessary in order to add a new VLAN to the Ezonexam switched network? (Select all that apply)
  • 正确答案 :ABD
  • Create the VLAN.

    Name the VLAN.

    Add the desired ports to the new VLAN.

  • 解析:解析:Explanation:

  • [单选题]为了查看路由器的E0端口上,是否挂接了访问权限表,应该使用的命令是()
  • 正确答案 :B
  • show interface e0


  • [多选题]You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?
  • 正确答案 :ABCDE
  • Switch(config) switchport trunk encapsulation isl

    Switch(config) switchport trunk encapsulation ietf

    Switch(config-if) switchport trunk encapsulation isl

    Switch(config-if) switchport trunk encapsulation ietf

    Switch(config-if) switchport trunk encapsulation dot1q

  • 解析:解析:Explanation:

  • 查看原题

    推荐下载科目: 计算机三级 计算机四级 软考中级 思科认证 华为认证 计算机一级 软考高级 软考初级 计算机操作员初级 计算机操作员中级
    @2019-2026 不凡考网 www.zhukaozhuanjia.com 蜀ICP备20012290号-2