1. [单选题]交换机工作在OSI七层模型的哪一层()
A. 物理层
B. 数据链路层(data link layer)
C. 网络层
D. 传输层
2. [多选题]请选出交换机处理帧的三种模式：()
A. 直通模式
B. 存储转发模式
C. 侦测模式
D. 分段模式
E. 阻塞模式
3. [单选题]在OSI七层模型中，介质工作在哪一层()
A. 传输层
B. 会话层(session layer)
C. 物理层
D. 应用层
4. [单选题]Assuming you build networks to exact specifications, what is the recommended maximum length a 10BaseT cable can be before it has to be segmented or repeated?
A. 100 meters
B. 100 feet
C. 100 yards
D. 200 meters
E. None of the above
5. [单选题]IP扩展访问列表的数字标示范围是多少（）。
A. 0-99
B. 1-99
C. 100-199
D. 101-200
6. [单选题]The network administrator has configured port security on a Ezonexam switch. Why would a network administrator configure port security on this Ezonexam device?
A. To prevent unauthorized hosts from getting access to the LAN
B. To limit the number of Layer 2 broadcasts on a particular switch port
C. To prevent unauthorized Telnet or SSH access to a switch port
D. To prevent the IP and MAC address of the switch and associated ports
E. None of the above
7. [多选题]There are 2 switches in the Ezonexam LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link. Which of the conditions below would verify trunk and VLAN operation? (Select all valid answers)
A. Host 1 on VLAN 1 can ping Host 2 on VLAN 1
B. Host 1 on VLAN 1 can ping Host 4 on VLAN 2
C. Host 1 on VLAN 1 can not ping Host 2 on VLAN 1
D. Host 4 on VLAN 2 can not ping Host 1 on VLAN 1
E. Host 4 on VLAN 2 can ping Host 2 on VLAN 2
8. [单选题]You want to upgrade the Ezonexam LAN so that all ports operate in full duplex mode. Which statement is true about full-duplex Ethernet when comparing to half-duplex Ethernet?
A. Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B. Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C. Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D. Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E. None of the above
9. [单选题]查看路由表的命令是：()
A. show interface
B. show run
C. show ip route
D. show table
10. [多选题]The LAN needs are expanding at the Ezonexam corporate office, which is quickly growing. You are instructed to enlarge the area covered by a single LAN segment on the Ezonexam network.Which of the following are layer 1 devices that you can use? (Choose all that apply.)
A. A switch
B. A router
C. A network adapter card
D. A hub
E. A repeater
