1. [多选题]As a Ezonexam trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?
A. TestKSwitch(config) ip route-default 192.168.1.115
B. TestKSwitch(config) ip default-gateway 192.168.1.115
C. TestKSwitch(config) ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config) ip default-network 192.168.1.115
E. None of the above
2. [单选题]The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?
A. Assign the switch a higher MAC address than the other switches in the network have
B. Establish a direct link from the switch to all other switches in the network
C. Configure the switch full-duplex operation and configure the other switches for half-duplex operation
D. Configure the switch so that it has lower priority than other switches in the network
E. None of the above
3. [单选题]On a half-duplex Ethernet LAN, two hosts attempt to send data simultaneously, resulting in a collision. Following this collision, what will the hosts do? (Select all valid answers)
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
4. [单选题]在OSPF的DR/BDR选举过程中，在路由器有相同的接口优先级情况下，什么用于确定DR或BDR（）
A. 最高的OSPF进程ID
B. 最低的接口IP地址
C. 最低的接口开销
D. 路由器ID
5. [单选题]You need to perform. some initial configuration tasks on a new Ezonexam switch. What is the purpose of assigning an IP address to a switch?
A. To provide local hosts with a default gateway address
B. To allow remote management of the switch.
C. To allow the switch to respond to ARP requests between two hosts
D. To ensure that hosts on the same LAN can communicate with each other.
E. None of the above
6. [单选题]On the topic of VLSM, which one of the following statements best describes the concept of the route aggregation?
A. Deleting unusable addresses through the creation of many subnets.
B. Combining routes to multiple networks into one supernet.
C. Reclaiming unused space by means of changing the subnet size.
D. Calculating the available host addresses in the AS.
E. None of the above
7. [单选题]How can a Ezonexam administrator determine if a router has been configured when it is first powered up?
A. A configured router prompts for a password
B. A configured router goes to the privileged mode prompt
C. An un configured router goes into the setup dialog
D. An un configured router goes to the enable mode prompt
8. [单选题]EIGRP的管理距离（）
A. 90
B. 100
C. 110
D. 120
9. [单选题]You have just purchased a brand new router and wish to have the router prompt you through the initial configuration commands. Which router mode does this describe?
A. ROM Monitor mode
B. SETUP mode
C. Autoflash mode
D. RXBOOT mode
E. None of the above
10. [单选题]两台路由器直连到一起，应该使用的线缆为（）
A. 交叉线缆
B. 直通线缆
C. 反转线缆
D. 任意线缆
