1. [单选题]Which type of cable should be used to make a connection between the Fa0/0 port on a router and the Fa0/0 port switch?
A. Rollover cable
B. Console cable
C. Crossover cable
D. Straight-through cable
E. Serial cable
2. [单选题]以下特殊区域中哪一个没有自动下发缺省路由（）
A. 末梢区域
B. 完全末梢区域
C. NSSA区域
D. 完全NSSA区域
3. [单选题]After working all night and successfully configuring a Cisco router for the Ezonexam network you save your changes on the startup config, reboot the router, and go out for a cigarette. When you return, none of your changes are active and the router boots to the initial configuration mode! Which of the choices below indicates the source of your problem?
A. Hardware failure in NVRAM prevents the router from loading the config
B. Startup-config in flash is corrupt and cannot be analyzed
C. Router configuration-register set to bypass startup configuration
D. Startup-config in NVRAM is corrupt and cannot be analyzed
E. None of the above
4. [多选题]When you compare the differences between half-duplex and full-duplex Ethernet, which of the following characteristics are exclusive to half-duplex? (Select two answer choices)
A. Half-duplex Ethernet operates in a shared collision domain.
B. Half-duplex Ethernet operates in an exclusive broadcast domain.
C. Half-duplex Ethernet has efficient throughput.
D. Half-duplex Ethernet has lower effective throughput.
E. Half-duplex Ethernet operates in an exclusive collision domain.
5. [多选题]Using a subnet mask of 255.255.255.224, which of the IP addresses below can you assign to the hosts on this subnet? (Select all that apply)
A. 16.23.118.63
B. 87.45.16.159
C. 92.11.178.93
D. 134.178.18.56
E. 192.168.16.87
F. F. 217.168.166.192
6. [单选题]标准访问控制列表应被放置的最佳位置是在（）。
A. 越靠近数据包的源越好
B. 越靠近数据包的目的地越好
C. 无论放在什么位置都行
D. 入接口方向的任何位置
7. [单选题]OSI七层模型中，数据链路层(data link layer)的数据封装名称为（）
A. 比特
B. 帧
C. 包
D. 段
8. [单选题]下列对RIP的配置中，合法的命令是（）
A. router rip 100 network 10.12.0.0
B. router rip 100 network 10.0.0.0
C. router rip network 10.12.0.0
D. router rip 100 network 10.0.0.0
9. [单选题]When is a switched network that is running the Spanning Tree Protocol considered to be fully converged?
A. when all switches have the same BID as the root switch
B. when all switches have received the MAC address of each neighboring switch
C. when every enabled switch port has been assigned a unique identifier
D. when every operating switch port is in either the blocking or forwarding state
E. when all switches are in either client, server, or transparent mode
10. [单选题]对于使用链路状态路由协议的路由器如何选择最佳路线到达子网，下列哪项是正确的（）
A. 路由器会发现链路状态数据库中的最佳路由
B. 通过针对链路状态数据库中的信息运行SPF算法，路由器会计算出最佳路由
C. 路由器将比较每个邻居接收到的更新中为子网列出的标准，并挑选最佳标准路由
D. 路由器会使用具有最低条数的路径
